Get the optimum out of your CNC-Controller with smOOver.opt! Upgrade now to stepper motor driver with reduced power losses and low-vibration microstep drive! Plug&Play uUpgrade for CNC-Controller III and CNC-Controller VI.
Features:
• Adaptor board for smOOver.drv, for installation in CNC-Controller III and VI
• Enables micro step from 1/256 to 1/4-, half-, and fullstep
• Significant reduction of electrical power losses compared to original CNC controller card
• Higher output voltage to achieve higher motor speed
• Adjustment of motor current and step width with rotary switches
• Additional settings with DIP switches
• Can be used as an evaluation board for smOOver.drv as well, e.g. in combination with BOB Interface II
• Made in Germany
included in delivery:
• Printed circuit board assembled and tested
• Distance bracket (aluminium bracket and PCB mounting)
• Manual
Note: Driver board smOOver.drv (art. no. 1461) needs to be ordered separately!
New, now available!
stepping motor 56*56*56mm (Nema23)
1.4Nm, 3.0A
stepper motor driver up to 2.25A/35V
microstep, short circuit proof
This Product was added to our catalogue on 23/04/2018.