Features:
* 1 stepper motor channel
* Connect up to 4 boards to PC printer port by using the universal interface board
* Easy adjustable motor current 1A up to 7A each phase in steps of 0.5A (with rotary switch)
* 25-85 Volt DC motor power supply
* only one supply voltage necessary
* TTL-compatible in- and outputs (5Volt)
* Inputs and outputs are galvanicaly isolated with optocouplers
* compatible to common CNC software (Win-PCNC, Mach3, Step4, CNC-profi, EMC etc.)
* 1/20-, 1/10-, 1/5,- 2/5,- 1/16-, 1/8-, 1/4-, half- and fullstep
* Automatic current reduction (can be disabled)
* reduction of motor resonances (can be disabled)
* Short circuit protected
* LED Display for status information
* Size: 117*85*28mm

included in delivery:
* printed circuit board, assembled and tested
* setup instructions

Important note: Due to the high input currentof the optocouplers, it is not recommended to connect the Eurostep directly to the printer port. Instead, we recommend the use of the "Stepper interface board II". For fast and easy wiring, there is an adaptor cable available.